DS-K1TA70MI-T face recognition terminal is a kind of access control device integrated with temperature screening function.

It can fast taking skin-surface temperature and upload abnormal temperature event to the center, 

which can be widely applied in multiple scenarios, such as enterprises, stations, dwellings, factories, schools, campus and so on.

 Supports Vanadium Oxide uncooled sensor to measure target's temperature

 Temperature measuring range: 30 °C to 45 °C (86 °F to 113 °F), accuracy: 0.1 ° C, deviation: ± 0.5 °C

 Recognition distance: 0.3 to 1.8 m

 Fast temperature measurement mode: Detects face and takes temperature without identity authentication

 Multiple authentication modes are available: card and temperature, face and temperature, card and face and temperature, etc

 Face mask wearing alert: If the recognizing face does not wear a mask, the device will prompt a voice reminder. At the same time, the authentication or attendance is valid

 Forced mask wearing alert: If the recognizing face does not wear a mask, the device will prompt a voice reminder. At the same time, the authentication or attendance will be failed

 Displays temperature measurement results on the authentication page

 Triggers voice prompt when detecting abnormal temperature

 Configurable door status (open/close) when detecting abnormal temperature

 Transmits online and offline temperature information to the client software via TCP/IP communication and saves the data on the client software

 Face recognition duration ＜ 0.2 s/User; face recognition accuracy rate ≥ 99%

 6000 face capacity, 6000 card capacity, and 100,000 event capacity

 Suggested height for face recognition: between 1.4 m and 1.9 m

 Supports 6 attendance status, including check in, check out, break in, break out, overtime in, overtime out

 Watchdog design and tamper function

 Audio prompt for authentication result

 NTP, manually time synchronization, and auto synchronization

 Connects to external access controller or Wiegand card reader via Wiegand protocol

 Connects to secure door control unit via RS-485 protocol to avoid the door opening when the terminal is destroyed

 Imports and export data to the device from the client software

 * Biometric recognition products are not 100% applicable to anti-spoofing environments. If you require a higher security level, use multiple authentication modes.

 * In order to get an accurate temperature, after the device is powered on, you should wait for 90 min to warm the device up.

 contact: info@vikylin.com